Do-It-Yourself Plug & Play Accessory Lead HONDA CRF 250L/300L & Rally

Fits 2017-2027 Honda CRF250L, CRF300L, CRF250L Rally and CRF300L Rally. Choose your model when ordering, because the standard bikes and the Rallys use different versions.

Wiring your own GPS, heated grips or other accessory? This lead plugs into Honda's factory switched accessory connector and gives you a clean 12-volt feed at the cockpit.

• Genuine Honda connector: waterproof, the same one the bike uses.
• 18-inch lead: two wires, 18-gauge red (+12V) and black (ground), in an abrasion sleeve. It follows the factory harness to the instrument cluster or bars.
• Posi-Lock ends: hand-tighten in-line connectors, no crimping or soldering, and reusable. Instructions are included.
• Zip ties: two are included.

Where the factory connector is:

• Standard CRF250L/300L: in a black vinyl boot behind and below the right side of the headlight. 15 A circuit.
• Rally models: clipped inside the left front fairing. 10 A circuit, fuse #5.

Install: about 10 minutes with common hand tools. Unclip the factory cap, plug in the lead, and connect your accessory. Nothing is cut. Photo instructions are included.
Download the MotoStuff installation guide (PDF)

Power: the circuit is switched, so it's on only with the ignition. Keep the total draw under your bike's rating (15 A standard, 10 A Rally). Typical draws:

• Heated grips: 3-5 A
• USB charger: 1-2 A
• Heated gloves: 3 A
• Heated pants: 6 A
• Heated jacket: 8 A