Auxiliary Accessory Leads 2019-2026 HONDA CRF 450L / 450RL

Fits 2019-2026 Honda CRF450L and CRF450RL.

Honda fitted a switched 10-amp accessory connector to the 450L. It's clipped to a metal bracket just behind the bottom of the left radiator (see the listing photos), but Honda never sold a lead for it. This kit uses genuine Honda waterproof connectors and an 18-inch two-wire 18-gauge lead with an abrasion sleeve. The lead follows the factory harness up to the left upper triple clamp.

Choose your version:

• Dual USB A&C: illuminated USB-A and USB-C charger, 3 A output with a blue light, and a water-resistant spring-loaded cover. (The installed photos show the earlier USB-A-only unit, which this replaces.)
• 12-volt socket: cigarette-lighter style, OEM look, water-resistant spring-loaded cover.

Install: a few minutes with a 10mm wrench. Bolt the bracket to the upper triple clamp, route the lead along the factory harness, and plug it into the connector behind the left radiator. Two zip ties are included.

Download the MotoStuff installation guide (PDF)

Power: this is a 10-amp switched circuit, so it's on only with the ignition. Typical draws:

• Heated grips: 3-5 A
• USB phone charger: 1-2 A
• Heated gloves: 3 A
• Heated pants: 6 A
• Heated jacket: 8 A

Most high-output horns draw too much for this circuit. If you're running a 12-volt compressor, check that it pulls under 10 A, or use one that connects to your battery-tender SAE lead.